Eagle 320 Manuale Utente Scaricare il pdf (Pagina 33)

Page 31 of 32 P/N 595176-01 Rev. C 1/11

HOUSING BUMPER

1. To remove the housing bumper, remove just the screws holding the two

bottom strap brackets as described above in REMOVE AND REINSTALL

HAND STRAPS. Peel the housing bumper off of the camera housing.

2. On the left side of the camera next to the threaded insert, there is an elec-

trical connector with a rubber protective cap. Before reinstalling housing

bumper, verify that the rubber protective cap is securely tted over the

electrical connector.

3. To reinstall the housing bumper, orient the housing bumper so that the two

ridge bars in the inside of the bumper align with the two grooves in the

4. Thread the two screws through the bottom strap brackets, through the holes

in the housing bumper, and into the threaded inserts in the housing. Tighten

both screws to a torque of 6 inch-pounds (+/-1 inch-pound) / .7 N-m (+/-.1

N-m).

REMOVE AND REINSTALL BUMPERS

BATTERY BUMPER

The battery bumper stretches to t around the base of the handle just above

the battery.

1. To remove the battery bumper, gently pull the wide section of the bumper

away from the handle and release the narrow band from the groove in the

handle.

2. To reinstall, orient the bumper to

align with the screw lug on the

front of the handle and stretch the

narrow band to t in the groove

in the handle. The wide section

of the bumper must seat around

the screw lug on the handle.

Verify that the narrow band is fully

seated in the groove and will not

interfere with batter installation.

See FIGURE 24.

FIGURE 24

SCREW

LUG

camera housing. Place the hous-

ing bumper on the camera hous-

ing. When properly positioned,

the screw holes in the bumper will

align with the threaded inserts in

the housing. See FIGURE 25.

FIGURE 25

GROOVES

RIDGE

BARS

1 2 ... 28 29 30 31 32 33 34 35 36

Commenti su questo manuale

Nessun commento

Eagle 320 Manuale Utente Pagina 33

Commenti su questo manuale