Eagle 320 Manuale Utente Scaricare il pdf (Pagina 32)

Page 30 of 32P/N 595176-01 Rev. C 1/11

3. Thread one screw through the top strap bracket and into the threaded

insert in the housing. Tighten to a torque of 6 inch-pounds (+/-1 inch-

pound) / .7 N-m (+/-.1 N-m).

To reinstall hand straps, proceed as

follows:

1. Orient the strap so the strap

bracket with the neck strap D-ring

is closest to the display and the D-

ring and tri-slide buckle are facing

down.

2. Position the top strap bracket so

the alignment tab on the housing

body ts into the slot below the

strap. See FIGURE 22.

FIGURE 22

ALIGNMENT

TAB

CAUTION

DO NOT OVER TIGHTEN THE SCREWS BEYOND THE TORQUE SPECI-

FICATION. OVERTIGHTENING MAY DAMAGE THE CAMERA HOUSING

WHICH COULD LEAD TO FAILURE OF THE CAMERA.

REMOVE AND REINSTALL HAND STRAPS

To remove the hand straps, use an 1/8” / 3mm hex wrench to loosen and re-

move the screws (two) securing the ends of each strap. The outer covers are

secured with hook-and-loop fastener.

6. Thread the other screw through

the bottom strap bracket, through

the hole in the housing bumper,

and into the threaded insert in the

housing and tighten to a torque of

6 inch-pounds (+/-1 inch-pound) /

.7 N-m (+/-.1 N-m).

7. Replace the strap cover by

wrapping it around the strap

and securing the hook-and-loop

fastener. See FIGURE 23.

FIGURE 23

4. Verify that the housing bumper is properly positioned on the camera

housing. See REMOVE AND REINSTALL BUMPERS section below.

5. Lay the strap at against the camera housing with the D-ring and tri-slide

buckle facing up and align the hole in the bottom strap bracket with the

threaded insert in the housing. Only one side of the housing has an

alignment tab for the bottom strap bracket.

REMOVE AND REINSTALL BUMPERS

ON NEXT PAGE...

8. Repeat steps 1 through 7 for hand strap on opposite side of camera.

1 2 ... 27 28 29 30 31 32 33 34 35 36

Commenti su questo manuale

Nessun commento

Eagle 320 Manuale Utente Pagina 32

Commenti su questo manuale