
Page 22 of 32P/N 595176-01 Rev. C 1/11
VIDEO TRANSMITTER
The EAGLE IMAGER 320 Thermal Camera may be equipped with an optional
wireless transmitter to transmit the images as seen in the display screen to
the Video Receiver Kit. SCOTT Video Receiver Kits are available to provide
an interface to view the display output of the EAGLE IMAGER 320 Thermal
Camera on a remote video monitor (not included). Refer to the FCC registration
requirements as stated in this instruction.
The EAGLE IMAGER 320 Thermal Camera has a selectable two channel trans-
mitter. When properly setup, more than one camera can transmit to a single
Video Receiver permitting the use of multiple cameras in the same area.
The EAGLE IMAGER Video Receiver Kit permits the reception of the video im-
age transmitted by a properly equipped SCOTT EAGLE IMAGER 320 Thermal
Camera. The kit consists of a video receiver, a receiver antenna, both AC and
DC power adapters, and interconnection cables. The receiver two channel con-
guration provides a switchable interface to view the display output of separate
EAGLE IMAGER 320 Thermal Cameras on a video monitor and to record the
output on a video cassette recorder (monitor and VCR not included). Refer to
the instructions included with the Video Receiver Kit for complete details of
receiver operation.
NOTE
THE TWO CHANNEL EAGLE IMAGER 320 CAMERAS ARE ONLY COMPAT-
IBLE WITH THE SCOTT TWO CHANNEL RECEIVER KIT.
The following instructions explain how to identify and setup the EAGLE IMAGER
320 Thermal Camera for use with a VIDEO RECEIVER KIT.
1. Turn on the EAGLE IMAGER 320 as described in the USING THE EAGLE
IMAGER 320 Thermal Camera section of this instruction. After the initial-
ization screen, the thermal image will appear in the display.
2. The EAGLE IMAGER 320 Thermal Camera will power up in whatever
mode it was in when it was last powered off. If the transmitter is not
on, nothing will appear in the lower left corner of the display. See
FIGURE 18.
Commenti su questo manuale