Eagle 320 Manuale Utente Scaricare il pdf (Pagina 30)

Page 28 of 32P/N 595176-01 Rev. C 1/11

MAINTENANCE

NOTE

THE EAGLE IMAGER 320 THERMAL CAMERA HAS NO USER SERVICEABLE

PARTS EXCEPT AS INSTRUCTED IN THIS MANUAL. ANY OPERATIONAL

PROBLEMS SHOULD BE REFERRED TO AN AUTHORIZED SCOTT HEALTH

AND SAFETY SERVICE CENTER FOR REPAIR.

INSPECTION

Routinely inspect the EAGLE IMAGER 320 Thermal Camera for signs of wear

or damage.

– Check the strap handles for tears or weakness.

– Check the housing, display, and lens for cracks, scratches or other dam-

age that interferes with the performance of the camera.

– Verify that the rubber protective cap is securely fitted over the elec-

trical connector (on the left side of the camera, beneath the bottom

strap bracket).

If any damage is found that is beyond the scope of these instructions, tag the

unit for repair and contact an authorized SCOTT Health and Safety service

center or SCOTT Health & Safety for assistance.

CLEANING

The EAGLE IMAGER 320 Thermal Camera is factory sealed to protect the optics and

electronics from dirt and moisture. The camera should be cleaned when necessary

using a cloth dampened with a solution of mild detergent and water.

If the EAGLE IMAGER 320 Thermal Camera has been exposed to potentially haz-

ardous materials, decontaminate in accordance with established procedures.

The hand straps and the bumpers may be removed for cleaning or replace-

ment. See the REMOVE AND REINSTALL instructions below. Wash the

hand straps and bumpers in a solution of mild detergent and water and dry

thoroughly before reinstalling.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Nessun commento

Eagle 320 Manuale Utente Pagina 30